Do It Yourself Section My Garage Section Parts Look Up

Over 1,000,000 Orders Shipped Since 1997!

Flow Actuated Switches

Universal - Electrical Part - Flow Actuated Switches

Flow Actuated Switches: Is your Flow Actuated Switch not working properly? Jack's has the parts you need. Flow actuated switches operate at a variety of pressures and eliminate the need to restrict water flow to the pump, this helps prolong the pumps life. Check out our selection of Flow Actuated Switches below.

Featured: 2 Items Sort by  Result's per page
 

Barens OEM Part

TMT Flow Switch

Part Number: 5393
 
Specs
Equipment Type Pressure Washer
Tri-Magnet Technology In-Line Flow Switch
Microswitch Technology Eliminates Reed Switch
High Pressure In-Line Flow Switch
Can Be Mounted in Any Position
PSI 5000
Gallons Per Minute 12
Temperature 180° F
Inlet 3/8" FPT
Outlet 3/8" FPT
48", 18 awg lead length
Activates With As Little As 1.5GPM Flow

Fits Model

Replaces OEM
Universal :

Your Price:
$57.15
 
No Sales Tax, except in MD
Qty:

Barens OEM Part

TMT Flow Switch With Pilot Feature

Part Number: 5193
 
Specs
Pilot: 1/4" hose barb
Lead length: 48" 18awg
Electrical service life: 200,000 operations
PSI 4000
Micro switch technology eliminates reed switch
Highpressure inline flow switch
Activates with as little as .5 gpm flow
Minimal pressure drop up to 12 gpm
Mount in vertical position
Gallons Per Minute 12
Equipment Type Pressure Washer
Temperature 40°-180° F Operating Temperature
250 VAC switching voltage maximum
5 Amps switching current maximum
30 OHM contact resistance with leads
200,000 operations electrical service life
10 million operations mechanical service life
Inlet 3/8" FPT
Outlet 3/8" FPT
Install the flow switch VERTICALLY to the output side of the unloader, with the 2 conductor lead wires exiting from the top. If your system uses a downstream chemical injector, it should be mounted on the output side of the flow switch. Pilot model requires a direct connection to the water supply feed line to provide a pilot signal. This is accomplished by installing a tee fitting (with a 1/4" hose barb fitting) directly in the water supply feed line. The tube must be installed before the float valve. Install an appropriate length of 1/4" ID reinforced polyvinyl tubing between the tee fitting and the valve pilot port.

Fits Model

Replaces OEM
Universal :

Your Price:
$141.00
 
No Sales Tax, except in MD
Qty: