 |
     |
||||
|
|||||
|
|||||
 Picture shown may not be actual accumulator. |
ACCUMULATORS Accumulators are designed to extend the life of your pressure washer pump by reducing the pulsations that arise in the incoming water supply. The nitrogen filled accumulators absorb the "shock" of low water pressure instead of your pumps pistons, valves and packing. |
| ACCUMULATORS | |
| PICTURE | BUY HERE |
 |
ACCUMULATOR Install on the inlet of pump to extend pump and system life by reducing pulsations. Accumulator is to be pre-charged with nitrolgen to one-half the system operating pressure. Do not pre-charge beyond the rated system operating pressure. It is recommended that the accumulator be mounted pointing down as a safety precaution. This procedure allows the accumulator to remain cooler during system operation and prolongs the effective operating life of the accumulator bladder. Shelf life of the nitrogen pre-charge of accumulator is approximately six months before re-charging is necessary. It is recommended the nitrogen pre-charge be checked approximately every three months after installation in a pressure system.
CAN BE SHIPPED VIA GROUND SERVICE ONLY.
|
|
ACCUMULATOR
Install on inlet of pump to prevent pulsation. Check accumulator every three months to see it is properly charged.
Part# 2406 Our Price: $102.44 |
 |
HI PRESSURE ACCUMULATOR Install on inlet of pump to prevent pulsation and extend the life of the pump and system. Check every three months to see it is properly charged.
Part# 3104 Our Price: $127.10 |
|
||||||||||
