Number #1 For Lawn Mower Parts!
Over 1.2 Million Parts Available!

One of the major problems affecting the proper functioning of pressure washers is contaiminated water. By nature, water is a carrier of minerals, iron, dirt, rust, and other contaminants. Problems caused by this contamination could be clogging of the float tank, and pump inlet. The particles can get into the pump and cause wear on the packings and valves or crack the ceramic pistons. Unloaders are prone to damage if the water is not clean.

Every pressure washer system, whether it is pulling water from a city water supply, water tank, stream or pond shoud have a quality water filter installed on the inlet side of the pump.

Specifications:

• Rigid aluminum housing
• Stainless steel mesh filter
• Port for bypass hose
• Port for easy start valve
• Maximum Volume: 5.8 GPM
• Maximum Pressure: 145 PSI
• Maximum Temperature: 176 Degrees F.
• Inlet: 1/2" FPT
• Outlet: 1/2" MPT

One of the major problems affecting the proper functioning of pressure washers is contaiminated water. By nature, water is a carrier of minerals, iron, dirt, rust, and other contaminants. Problems caused by this contamination could be clogging of the float tank, and pump inlet. The particles can get into the pump and cause wear on the packings and valves or crack the ceramic pistons. Unloaders are prone to damage if the water is not clean.

Every pressure washer system, whether it is pulling water from a city water supply, water tank, stream or pond shoud have a quality water filter installed on the inlet side of the pump.

• 150 PSI maximum @ 70° F
• 100 PSI maximum @ 125° F
• 140° F. is maximum temp.

One of the major problems affecting the proper functioning of pressure washers is contaiminated water. By nature, water is a carrier of minerals, iron, dirt, rust, and other contaminants. Problems caused by this contamination could be clogging of the float tank, and pump inlet. The particles can get into the pump and cause wear on the packings and valves or crack the ceramic pistons. Unloaders are prone to damage if the water is not clean.

Every pressure washer system, whether it is pulling water from a city water supply, water tank, stream or pond shoud have a quality water filter installed on the inlet side of the pump.

• 150 PSI maximum @ 70° F
• 100 PSI maximum @ 125° F
• 140° F. is maximum temp.

The top is Polyamide while the bowl is Styrene-acrylonitrile, designed and produced in quality assurance with UNIEN ISO9001. Blue Max water filters are ergonomically designed, the head material and brass threads give good resistance.

Specifications:

• FDA Approved polyamide pressure relief valve
• 145 PSI working pressure
• 508 PSI Burst Pressure
• 122°F (50°C.) maximum temp.
• 400 to 1222 GPH flow rate

• Pressure Washers
• Food Service & Processing
• Laboratory Equipment
• Under sink residential water
• Reverse osmosis
• Vending Equipment
• Process fluids