Generators change-spark-plug-honda-eu2000i

Published on March 5th, 2015 | by Turner Anderson


Changing the Spark Plug on a Honda EU2000i Generator

Watch our video on how to replace the spark plug on a Honda EU2000i generator.

Changing your spark plug will increase the efficiency and extend the life of your engine. This video shows you how to easily replace your dirty spark plug with a new one.

Step 1:

Be sure the power switch is off and that all of the wires are unplugged, locate the spark plug on top of the unit under the mainetenance cover and disconnect the boot

Step 2:

Remove the spark plug with a socket wrench

Step 3:

Thread the new plug into the housing and then tighten with the wrench, do not over tighten

Step 4:

Reconnect the boot and the maintenance cover


Jack’s Safety Tips: Before servicing or repairing any power equipment, disconnect the spark plug and battery cables. Remember to wear appropriate safety glasses and gloves to protect against harmful chemicals and debris. View our Disclaimer.

Featured Parts and Products:

Tags: , ,

About the Author

is the Internet Marketing Manager at Jack's and the editor of Jack's DIY Center. You'll also find him creating How-To articles, videos, newsletters, and much more.

One Response to Changing the Spark Plug on a Honda EU2000i Generator

  1. Jim says:

    Where’s the part about checking the gap on the new spark plug ???

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top ↑