DIY for Husqvarna


Featured Husqvarna DIY Articles & Videos

Replacing the Mower Blade on a Husqvarna Lawn Mower

Replacing the Mower Blade on a Husqvarna Lawn Mower »

Replacing the Air Filter on a Husqvarna Chainsaw

Replacing the Air Filter on a Husqvarna Chainsaw »

Husqvarna DIY Articles & Videos

Husqvarna Parts

24 Responses to Husqvarna

  1. BUD LARSON says:


  2. neil meehhan says:

    Can you inform me on the best way to remove and replace deflector and control assembly on a Husqvarna snow blower model 1130 SBEXP (96195000200) (2006-06) the cable which directs snow for up and down broken off at handle assembly. I believe I will have to replace whole control assembly part # 585271701. Also I can replace Assembly w/o removing Plastic cover at the top ? Thanks for any assist. Neil Meehan

  3. neil meehhan says:

    Watched replacing chain on Husqvarna chainsaw. Noticed that instruction did not include making sure brake handle pulled into lock position on Rancher model before removing cover. I f not pulled back you will have to go to repair shop to get cover put back on. If anyone knows way to replace cover w/o making sure brake handle not in locked position would appre information. Thanks.

  4. kurt elarton says:

    I have a 2006 huskavarna 54in cut 24hp the battery keeps going dead even after a new one was placed any suggestions? Thanks kurt

  5. Bert Eakles says:

    I Have a gth2548 riding mower, it will cut grass until the battery goes dead while mowing {magnetic clutch for blade deck}. if I just run the engine and move the mower battery will last a long time.i need to know how to fix the charging system so I can run the mower longer

    • Sid1963 says:

      Hey,, I have a Husky YTH2348,,
      Blow out from under the flywheel, try too get it charging, then run down the loose connection.. Just TLC goes a long way. Small engines want too run, Just clean and lube it.
      Mine is scweeling when I let off the brake,, I think clutch.. Help Sid.

  6. Lisa King says:

    I have a Husqvarna CZ4817 zero turn riding mower that I just replaced the drive belt and ty-rod. It worked fine for 12 hours of mowing (4 different times).

    I was mowing last night, went to use the right arm to back up and it would barely move backwards. It moves forward just fine and turns just fine. It just want back up on the right side. Left side works fine in all directions. Please ya’ll any ideas on what to look for, where do I start?

    Thank you so much in advance.

  7. clyde torgerson says:

    We have the same problem as Lisa king it will only go in circle how do we fix it I can’t find a diagram to diagnose the problem I need help anyone.

  8. Roger Bushey says:

    I have a 16″ model 36 Hasqvarna Chain Saw that has inceasingly harder to start and cuts out when cutting or has a load on the engine. I have tried to adjust the set screws on the carburator but this has not helped. I plan on changing the spark plug but is there anything that I should be checking? Any suggestions on how to proceed?

    Second question. Are the parts on a Hasquvarna Model 36 compatible with a Hasqvarna Model 45 chain saw? The Hasqvarna 45 chain saw’s motor has lost compression and the Hasqvana 36 needs to have the carburator replaced. Can the Carburator on the model 45 be put into the 36 Model or the moter from the model 36 be put into the 45 Model?

  9. John Miller says:

    Hello I have a 455e rancher .. it seems to get no fuel and over heats then there is no spark at all ….it has happened twice .I have done maintenance on it and checked for issues but cant seem to figure this one out and maybe some one out there can email me with a solution


  10. Sid1963 says:

    How about getting a 48” too cut level, And the height to work from 1too 6” at the same time

  11. Andy says:

    My chock is not working, 2015 mower,

  12. pedro bermudez says:

    Hello, I have a blue bird SC550A sod cutter that keeps braking the axle in both transmission 539112854 and gearbox 539003131 , I´ve tried welding the m but they brake again, both gear box and transmission are huskvarna parts, expensive ones, can I get the axles , I there a repair shop I can contact


  13. bill says:

    my Husky lawn tractor # YTH 1542 XP .. 15.5 hp THE motor will Not turn .. it is Not seized up .. it has plenty of Oil in it.. .. I can turn the flywheel 1/2 inch , back and forth.. but that IS IT.

    you can hear it hit against metal to metal.. when I turn it by hand, back and forth, that 1/2 inch..

    it was running fine.. and just stopped while I was mowing.. .. HELP !

  14. James VanValkenburgh says:

    > have a mower 961450010 broken axel, have to replace transmission , not happy.

  15. How do you replace the pull starter on a housqvarna hedge trimer

  16. cb kitts says:

    I have a 1 year old husqvarna o turn mower, it runs fine until i cut for a while, then it will just quite. it will run fine with out a load, whats wrong ?

  17. Dean Goff says:

    I have a Husqvarna YTH22V46 riding mower. The mower starts, but the throttle control lever seems to have lost tension/connectivity to the carburetor. I cannot slow or accelerate the engine. I have checked the metal throttle cable for breaks or disconnects and have found nothing. Cleaned the carburetor, replaced the fuel filter, and installed a new air filter. No improvement or change.
    Can you suggest what I should do the resolve my problem.
    Thank you

  18. Tom says:

    I own a husqvarna gth 2654. The upper most belt that goes from the front engine pulley all the way back to above the rear axle ” That belt shredded on me. I am seeking information on how to change the belt and the proper route the belt runs on the pulleys. And how to get the belt on the engine pulley.

  19. anthony amato says:

    i have a Husqvarna 254 24 hp briggs n stratton engine.
    How do I replace the filter

  20. Penny thompson says:


Leave a Reply

Your email address will not be published. Required fields are marked *

Solve : *
3 + 27 =

Back to Top ↑