Snow Blowers replace-auger-cable-snow-blower

Published on February 10th, 2015 | by Turner Anderson


Replacing the Auger Cable/Rod on a Two Stage Snow Blower

Watch our video on how to replace the Auger Cable/Rod on a two stage snow blower.

The auger cable engages the auger and impeller on a two stage snow blower. If it is bent or broken, the auger and impeller will not rotate when you push down on the control lever.

Step 1:

Disconnect the spark plug and remove the ignition key

Step 2:

Remove the cotter pin

Step 3:

Remove the cable from the control

Step 4:

Disconnect the spring from control arm

To Install The New Cable:

Step 1:

Place spring hook through the hole in the control arm

Step 2:

Then connect the control arm to the control lever

Step 3:

Re-insert the cotter pin


Jack’s Safety Tips: Before servicing or repairing any power equipment, disconnect the spark plug and battery cables. Remember to wear appropriate safety glasses and gloves to protect against harmful chemicals and debris. View our Disclaimer.

Featured Parts and Products:

Tags: ,

About the Author

is the Internet Marketing Manager at Jack's and the editor of Jack's DIY Center. You'll also find him creating How-To articles, videos, newsletters, and much more.

2 Responses to Replacing the Auger Cable/Rod on a Two Stage Snow Blower

  1. Jerry says:

    I have a snow devil snowblower with I start it the anger start turning should that happen

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top ↑