Snow Blowers Replace Scraper Blade on Husqvarna Snow Blower

Published on February 3rd, 2015 | by Turner Anderson


Replacing the Scraper Blade on a Husqvarna Two Stage Snow Blower

Watch our video on how to replace the scraper blade on a Husqvarna two stage snow blower.

The scraper blade scrapes the surface of snow and ice underneath your snow blower, since the augers don’t come in contact with the ground. After constant use, the scraper blade will wear down and need to be replaced.

Step 1:

Remove the ignition key

Step 2:

Tilt the snowblower back so it rests on it’s handles

Step 3:

Remove the 5 blades that are holding the blade to the auger housing

Step 4:

Once all of the bolts are removed, remove the scraper blade

Step 5:

Align the holes in the bar with the holes in the housing and re-install the bolts

Jack’s Safety Tips: *Before servicing your snow blower make sure the snow blower is turned off and remove the ignition key to reduce the risk of accidental start-up. View our Disclaimer.

Featured Parts and Products:

Tags: , ,

About the Author

is the Internet Marketing Manager at Jack's and the editor of Jack's DIY Center. You'll also find him creating How-To articles, videos, newsletters, and much more.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top ↑