My Account | My Garage | Commercial/Dealer Login | Order Status |
Contact Customer Support
M-F: 9am-6pm ET
Sat: 9am-5pm ET
| 1-877-737-2787
Shopping Cart

Over 1,000,000 Orders Shipped Since 1997!

1565 Suttner ST-5 Vertical Mount Flow Switch

Barens 1565 Suttner ST-5 Vertical Mount Flow Switch

Part#:  1565
There are no reviews at this time.
Barens OEM Part



Suttner ST-5 Vertical Mount Flow Switch

Fits Model


Also Fits Model


Replaces OEM



Inlet 3/8" FPT
The ST-5 is a "normally open" flow switch, designed to be mounted in a high pressure water line. Inside the housing is a floating magnet which is aligned parallel with a reed switch. When the water flow is initiated, ususally by pulling the spray gun trigger, the water flow forces the magnet to move forward. Once in the correct position, the magnet pulls the thin reeds together, closing the circuit and allowing electrical continuity. When water flow ceases, usually when the trigger is released, gravity returns the magnet to its original position. the reeds then pull apart and open the circuit, stopping electrical continuity.
Mounts further downstream in pumping system than traditional vacuum switches, therby minimizing potential leak points that can cause vacuum switches to close.
Vacuum switches use rubber diaphragms that often rupture and cause vacuum leaks to the pump
Flow switches operate at a variety of pressures
Flow switches eliminate the need to restrict water flow to the pump, thereby prolonging pump life
the reed switch is encased in a protective glass capsule with a sealed nitrogen atmosphere that eliminates exposure to corrosive cleaning chemicals
Mounting Position: Vertical only
Magnet Configuration: Free floting
Cord/Lead Length: 47 inches
WIRING INSTRUCTIONS: Lead #1 to Line/Power, Lead #2 to Load Yellow with green tracer to Ground
Reed Switch Adjustment: depending on the system flow, it is normal for the magnet position to vary. This variance may require adjustment of the reed switch upon initial installation, especially at lower flow rates. If the switch fails to close upon initial flow, simply loosen the adjustment screw and position switch so it properly opens/closes according to flow conditions.
Gallons Per Minute 1-8
Outlet 3/8" FPT
Weight 16oz
Equipment Type Pressure Washer
PSI 75-3600 PSI

Customer Reviews for the Suttner ST-5 Vertical Mount Flow Switch

There are no reviews for this product at the time.

Questions & Answers for the Barens 1565

Ask us about the Barens 1565 Suttner ST-5 Vertical Mount Flow Switch. Please no repair questions. Your Q&A may be posted to to help other shoppers, like you, with their purchasing decisions. Thank you.

Repair Tips For Barens 1565

No repair tips at this time.

back to top