How to Check the Engine-Oil Level on a Toro SmartStow Recycler Lawn Mower
The following instructions are for the Toro SmartStow Recycler Lawn Mower, which is for model number 20339. Before attempting to work on/with your equipment in any way, always refer to your owner’s manual for safety information.
- Move the machine to a level surface.
- Remove the dipstick by rotating the cap counterclockwise and pulling it out.
- Wipe the dipstick clean with a clean cloth.
- Insert the dipstick into the oil-fill tube, then remove the dipstick.
- Read the oil level on the dipstick.
- If the oil is below the Add mark on the dipstick, slowly pour a small amount of oil into the oil-fill tube, wait 3 minutes, and then repeat steps 3 through 5 until the oil level is at the Full mark on the dipstick.
- If the oil is above the Full mark on the dipstick, drain the excess oil until the oil level is at the Full mark on the dipstick.
- Important: If the oil level in the crankcase is too low or too high and you run the engine, you may damage the engine.
- Install the dipstick into the oil-fill tube securely.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
