How to Clean the Mower Housing for a Toro e-Cycler Cordless Lawn Mower
The following instructions are for the Toro e-Cycler Cordless Lawn Mower, which is for the model number 20360. Before attempting to work on/with your equipment in any way , always refer to your owner’s manual for safety information.
- Before cleaning the mower, stop the motor, wait for all moving parts to stop, and remove the key from the plug receptacle.
- Notice: Do not spray or pour water on the mower when cleaning. Moisture can get trapped in the mower and cause corrosion of internal parts.
Cleaning After Each Use
- Clean the underside of the mower housing. Be particularly careful to keep the front cavity clear of all grass clippings and debris. Remove dirt and grass clippings with a hardwood scraper, avoid burrs and sharp edges.
- Brush all the grass clippings and debris off the top of the mower housing after every use.
Cleaning After Each Season
- Remove the top shroud and clean out any grass clippings and debris from underneath it and around the battery with compressed air, a vacuum cleaner, or a brush.
- Notice: Do not use metal objects to clean around the battery. If metal objects contact the positive and negative posts at the same time, this may short out the battery. The battery or the conductor may overheat and cause burns.
- Check for any discolored or charred wires and battery and switch contacts. If any are damaged, contact an Authorized Service Dealer for repair.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
