How to Remove a Battery for an Ariens Apex
The following instructions are for the Ariens Apex, which are for the Apex 48 #991153, and Apex 52 #991155 mower models. Before attempting to work on/with your equipment in any way, always refer to your owner’s manual for safety information.
Remove Factory Battery
- Place the unit in service position.
- Disconnect the negative cable and then the positive cable from the battery.
- Loosen the hex nut securing the right hold-down bracket to frame.
- Remove the T bracket from lower slots in the hold-down brackets.
- Remove the battery.
Remove U1 Battery
- Place the unit in service position.
- Disconnect the negative cable and then the positive cable from the battery.
- Loosen the hex nut securing the right hold-down bracket to the frame.
- Remove the T bracket from the upper slots in the hold-down brackets. Retain this for reinstallation.
- Remove the battery.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
