How to Remove a Mower Deck for a Husqvarna YT48DXLS
The following instructions are for the Husqvarna YT48DXLS #96043022600 mower model. Before attempting to work on/with your equipment in any way, always refer to your owner’s manual for safety information.
- Place the attachment clutch in the “DISENGAGED” position.
- Lower the attachment lift lever to its lowest position.
- Remove the mower belt from the electric clutch pulley.
- Disconnect the front link from the mower, remove the retainer spring and the washer.
- Go to either side of the mower and disconnect the mower suspension arm from the chassis.
- Disconnect the rear lift link from the rear mower bracket, remove the retainer springs and washers.
- Go to the other side of the mower and disconnect the suspension arm and rear lift link.
- Slide the mower deck out from under the right side of the tractor.
For more information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
