How to Start and Stop a Mower for a Toro e-Cycler Cordless Lawn Mower
The following instructions are for the Toro e-Cycler Cordless Lawn Mower, which is for the model number 20360. Before attempting to work on/with your equipment in any way , always refer to your owner’s manual for safety information.
Starting the Mower
- Push the mower onto a flat concrete or asphalt surface.
- Note: Starting the mower in thick grass could cause the mower to clog.
- Insert the key fully into the plug receptacle.
- Squeeze the control lever to the handle.
- Note: Keep the mower running when turning the mower. Turning the mower off when making a turn does not save battery energy.
Stopping the Mower
- Release the control lever.
- Warning: Always remove the key from the plug receptacle when leaving the mower unattended, even for a short period of time.
- Remove the key from the plug receptacle if the mower will be unattended for any period of time. Store the key in a place out of the reach of children.
- Charge the battery.
- Note: Always charge the battery immediately after using the mower. If you do not charge the battery after each use, you will shorten the battery life.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
