How to use the Water Washout Feature on a Husqvarna HU700F
The following instructions are for the Husqvarna HU700F Lawn Mower, which is for the part number 96145000901. Before attempting to work on/with your equipment in any way, always refer to your owner’s manual for safety information.
Your lawn mower is equipped with a fitting that allows and easy cleaning of the underside of the housing.
- Move the lawn mower to an area of cut grass or another hard surface.
- Note: Water, grass and other debris will drain from beneath the mower housing during the washout process.
- Remove the grass catcher and discharge the chute assembly from the lawn mower.
- Close the mulcher door (if equipped).
- Connect a garden hose to the fitting where shown.
- Important: Be sure the garden hose is not routed under the lawn mower housing or entangled in the wheels.
- Turn on the water supply and check for leaks at the fitting.
- If no leaks are present, start the engine and let the engine run until the underside of the lawn mower is clean.
- Shut off the engine.
- Shut off the water supply and remove the hose from fitting.
- Start the engine and let the engine run for a full minute to remove excess water from the mower.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
